Boa 474B EZSDEI474B Programming Instructions

BOA EZSDEI474B
BOA 474B
The system comes with one transmitter. The receiver can store up to 2 different transmitter codes in memory.  Use the following to learn the transmitter or to
add a transmitter to the system. If power is lost to the control module (battery disconnected), the remote(s) must be relearned. The remote must not be closer than 3-feet from the control module when programming.
The following is the basic sequence of steps to remember whenever programming this unit:

  1. Fuses. Be sure to place the two 30-amp fuses into the relay harness RED wire fuse holders.
  2. Key. Turn the ignition to the ON position.
    1. Note: The system can only learn, after being connected and with the FIRST IGNITION ON. If not learned with the first ignition on the main power fuses will have to be disconnected from the BOA unit and then reconnected and the procedure repeated.
  3. Program. After 5-seconds, the parking lights will flash twice, press and hold the PROG button on the remote, until the doors lock and unlock or the lights flash (approximately 5-seconds).
    1. A second transmitter can only be added to the system immediately after programming the first transmitter. To add a second transmitter hold the PROG button for 5 seconds (within 5-seconds of the first transmitter parking light flash learn acknowledgment). When programming a remote ensure to hold the remote about 4-feet away from the BOA unit. If the remote is too close to the unit, the remote may not program.
  4. The parking lights will flash twice or the locks will cycle to acknowledge programming of this transmitter.
  5. Program. After 5-seconds, the parking lights will flash twice, press and hold the PROG button on the remote, until the doors lock and unlock or the lights flash (approximately 5-seconds).
  6. Remove key, put fuses into the relay harness red wire fuse holders.
  7. Test: Make sure that the vehicle is in park with the emergency brake on and the hood closed. Press Start twice on the remote to initiate remote start. 

Leave a Reply

Your email address will not be published. Required fields are marked *