Share

Tuesday, September 6, 2016

Valet 474T & Python 474P EZSDEI474P How to replace the case-shell-housing





To replace the housing of your keyfob:

  1. Stick a very small flat-head screwdriver into the small opening as shown in the video.  Pry apart until it snaps open.  Then use fingers to open it completely.
  2. Take the circuit board out of your old remote.  Since you are doing this, you might as well replace the battery with a new one.
  3. Put it in the new case making sure the battery is facing the correct direction.
  4. Close the top and bottom shells.

No comments:

Post a Comment