Share

Friday, March 11, 2016

[Remote of the Day] Code Alarm CATX510 (FCC ID: ELVATCG)

The FCC ID is ELVATCG and the code alarm part number is CATX510.  
CATX510 replacement transmitter
It works on these Code Alarm systems: CA510 and CA510A.
In order to complete the programming of new remotes, it helps to have a valet switch installed with the system.  If not it is still possible but you'll need to access the receiver under the dash.  Here is an article addressing programming without a valet switch.
If you already ordered a remote elsewhere and it didn't come with instructions you can get them here.
Changing the Remote Control Battery
The 12-volt alkaline battery supplied in your remotetransmitter should last approximately one year, depending onusage. When the battery begins to weaken, you will notice adecrease in range, or the distance from your vehicle thatyour remote transmitter will operate. Follow the instructionsbelow tochange the remote transmitter battery.
1.Insert the edge of a coin into the slot at the side of theremote control. Twist the coin to pry the remote controlhalves apart.
2.Remove the old battery and replace with a new one.Be sure to observe the (+) and (-) signs in the batterycompartment.
3.Carefully snap the case halves back together, then testthe remote control.

No comments:

Post a Comment